Tuesday, May 15, 2018

Versatile & basic card using Stampin' Up! products


This basic template will work with just about any Designer Series Paper and any stamped sentiment. The die is currently available. Imagine the possibilities with your paper scraps! If you make one, make 10 more to have on hand.

All images © 1990-2017 Stampin’ Up!® 


Supplies:
  • Stamp Sets – Picture Perfect Birthday (145519) 
  • Card Stock – Berry Burst (144243); Whisper White (100730); Basic Black (121045)
  • Stamp Pads – Tuxedo Black Memento Ink (132708)
  • Miscellaneous – Picture Perfect Party 6x6 Designer Series Paper (DSP)  (145559) , Glitter & Clear Epoxy Shapes (145632); Basic Black Solid Bakers Twine (141682); Celebrate You Thinlits Dies (146840); Multipurpose Adhesive Sheets (144106); Stampin' Dimensionals (104430); Banner Triple Punch (138292); Basic Black Stampin’ Write Marker (100082)
        
Measurements:  
  • Berry Burst Card Stock: 5 1/2” x 8 ½”   and 1 ½” x 4”
  • Basic Black Card Stock: 3 7/8” x 5 1/8”
  • Whisper White Card Stock:  3 ¾” x 5” and 4” x 5 ¼” (for inside)
  • DSP:  Striped Pattern 1” x 1 ¾” and Peach Pattern ¾” x 1 ½”         
  • Multipurpose Adhesive Sheets: 1 ½” x 4”
         
Instructions:
  1. Score the larger piece of Berry Burst card stock down the middle at 4 ¼” (along the 8-1/2” side). This will be your card base.
  2. Peel off the backing of the Multipurpose Adhesive Sheet and add it to the 1 ½” x 4” piece of Berry Burst cardstock.
  3. Cut out the word "celebrate" from this Berry Burst card stock. Note: make sure the card stock is facing up (adhesive sheet should be on the bottom).
  4. Using the black marker, ink up "the good stuff" and stamp it in the lower right corner of the smaller of the two Whisper White card stock pieces.
  5. Peel off the backing on the "celebrate" and stick it just above the words you just stamped.
  6. Add the Whisper White card stock to the center of the Basic Black card stock.
  7. Flag one end of each of the two pieces of DSP using the Triple Banner Punch and add them to the upper left corner of the Whisper White card stock.
  8. Add this panel to the card front using Dimensionals.
  9. Tie a bow from about 8” of black twine and adhere it to the center of the banners.
  10. Add three of the Glitter Epoxy Shapes to the card front.
  11. Stamp desired greeting using Memento ink on the second Whisper White piece of card stock. Note: I stamped the ‘today we celebrate wonderful brilliant fabulous you!’ greeting.
  12. Add this panel to the inside of your card.
Remember, you do not have to invent the wheel to be creative, just copy this project! Did you make it with your own hands? Then you have created!

Order any of these supplies by clicking on any image in this email or by linking to my 
ONLINE STORE.

No comments :

Post a Comment