Monday, March 13, 2017

Fairy Celebration Card using Stampin' Up! products




 
Fairy Celebration card created with Stampin' Up! productsAll images © 1990-2016 Stampin’ Up!® 
 
Stamp set found on page 63 of the 2016-17 annual catalog. See all images in this set below.

Supplies:
  • Stamp Sets: Fairy Celebration (C: 141554/ W: 141551), Places You’ll Go (P: 141741 )
  • Inks: Basic Gray Archival (140932), Sweet Sugarplum (141395), Tempting Turquoise (126952), Versamark (102283)
  • Paper: Shimmery White (101910), Basic Black (121045), Silver Glimmer (135314)
  • Other: Aqua Painters (103954), Fast Fuse (129026), Dimensionals (104430), Silver Metallic Thread (138402), Heat Tool (129053), Embossing Buddy (103083), Silver Embossing Powder (109131), Wink of Stella (141897)                        

Measurements:
  • Card Base in Basic Black: 11” x 4 ¼”  and scored at 5 ½”
  • Silver Glimmer Mat: 3-7/8” x 5-1/8”
  • Basic Black Mat: 3 ¾” x 5”
  • Silver Glimmer Mat: 2-5/8” x 4-3/8”
  • Shimmery White Mat (with Images): 2 ½” x 4 ¼” 

Instructions:
  1. Stamp image onto Shimmery White paper using Basic Gray Archival ink.
  2. Squeeze your Sweet Sugarplum and Tempting Turquoise ink pads to get some ink on the inside of the lids. This is where you will get your color from. Optionally, you can add color with a reinker.
  3. Using an Aqua Painter, paint the fairy’s dress with Sweet Sugarplum.
  4. Using your Wink of Stella, paint the fairy’s wings and fairy dust using Tempting Turquoise. Wipe your Wink of Stella brush on a paper towel to clean it.
  5. Use your embossing buddy on your Shimmery white image piece. Then stamp your sentiment in Versamark ink and heat emboss with silver embossing powder.
  6. Layer the Image Piece onto the corresponding Silver Glimmer layer with Fast Fuse.
  7. Use your Embossing Buddy on your Basic Black mat. Heat emboss fairy dust onto the top left and bottom right corners of the mat by stamping first in Versamark ink and heat embossing in Silver Embossing Powder.
  8. Wrap the Basic Black mat with the Silver Metallic Thread about 1/3rd of the way up from the bottom and adhere in back with Fast Fuse.
  9. Adhere the Basic Black Mat to the large Silver Glimmer Mat with Fast Fuse.
  10. Using Dimensionals adhere the Basic Black/Silver Glimmer piece to the Card Base.
  11. Using Dimensionals adhere the Image Piece/Silver Glimmer to the front of the card.
Remember, you do not have to be creative to create - just copy this project!
Order any of these supplies by linking to my ONLINE STORE.
 

No comments :

Post a Comment