Here is a Hello Fall card made with three sets including Holiday Home by Stampin' Up! This card has a bit more detail but TOTALLY worth the final outcome!
Supplies:
Measurements:
- Very Vanilla 5 ½” x 8 ½”; 4 ½” x 3 ¼”; 2 ¼” x ¾”
- Soft Suede 4” x 5 ¼”; 1” x 2” (for die cutting leaf)
- Cherry Cobbler 3 ¾” x 5”, 2 ½” x 1 ½” (for die
cutting house)
- Crushed Curry 1” x 2” (for die cutting leaf)
- Flashback DSP 2 ½” x 1 ½” (for die cutting house)
Instructions:
- Stamp the house with black ink onto the Flashback
DSP, Stamp again with Black ink onto small Cherry Cobbler Piece. Die
cut both pieces using the House Die. From the Cherry Cobbler house,
cut the roof and the door and adhere onto the DSP house. TIP: cut
the end of the chimney from the DSP house and glue it onto the cherry
cobbler roof to give it more of a layered dimension). Place a medium
size pearl at the door knob.
- To cut the ovals from both the Cherry Cobbler and the
Soft Suede – It’s easier if you adhere both layers together with just a
little bit of adhesive in the center. Be sure the Cherry Cobbler
layer is centered onto the Soft Suede. Using the 4th oval from the
center of the framelit set, cut through both layers. Now using the
next largest oval, cut only the Cherry Cobbler piece centering the oval
framelit with the smaller opening.
- Run the Cherry Cobbler piece through the Big Shot
using the Tiny Triangles Embossing Folder.
- Adhere the Cherry Cobbler embossed oval frame to the
soft suede oval frame, making sure the ovals are centered with each other.
- Using 2 strands of linen thread (about 4 ½” each) tie
and knot around the right edge of the oval frame.
- Stamp the trees from Lovely As A Tree onto the 4 ½” x
3 ¼” Very Vanilla card stock with Soft Suede ink.
- Stamp the small leaves randomly along the ground
using a variety of colors. Lightly sponge the sky using Soft Sky
Ink.
- Stamp the banner from the stamp set For All Things
using Crushed Curry Ink. Stamp Hello Fall on top of this…cut around
the banner using your scissors….no framelit here – sorry!
- Using the leaf framelit, die cut 2 leaves in each of
soft suede and crushed curry. Adhere these back to back with each
other catching the end of the linen thread in between the layers.
- Tape the Stamped Very Vanilla panel flat to the Very
Vanilla Card. Using dimensionals adhere the oval framed pieces to
your card.
- Using dimensionals adhere the house in the oval
section of your card. Also with dimensionals place your sentiment
onto your card.
Remember,
you do not have to be creative to create - just copy this project! Happy stamping!
No comments :
Post a Comment